DT SWISS - Upgrade Kit Star Ratchet SL with 54g

DT SWISS Upgrade Kit toothed washers SL with 54 teeth for Ratchet freewheel system 2 pcs.

Press fit end caps Removable by hand for quick conversions and service. +/- 0.0XX MM press fit tolerances.
BEARINGS High end catridge bearings throughout. Low friction thanks to single sided seals. 2080 N load capacity per bearing.
THREAD RING Takes up the inner ratchet, transfers torque to the hubshell. 450 Nm torque tested.
Lightweight alloy axles Optimized for the dynamic loads a hub undergoes. Tested to 13 standard lifecylces  of a wheel.
Ratchet springs Push the ratchets against each other to engage Tested to 13 standard lifecylces of a wheel.
Ratchets The best system to transfer torque at the lowest weight.
18 T / 20° engagement  |  36 T / 10° engagement  |  54 T / 6.6° engagement  |  options available
Alloy rotor bodies Lightweight and anodized. Super smooth surface finish of the contact area for the high precision, low friction rotary seal. +/- 0.0XX MM seal seat precision


With these toothed pulleys you can upgrade your DT Swiss hub with Ratchet freewheel system. With 54 teeth, they have three times as many locking points as the originally installed toothed discs and thus offer a noticeably less free travel until the adhesion is achieved. Especially for hard starts or in technically difficult terrain, the more direct power transmission offers significant advantages. Through a hollow milling of the toothed pulleys, the weight could also be pushed down by 10 grams per pair compared to standard toothed pulleys. The DT Swiss Ratchet System enables tool-free disassembly of the freehub body. Thus, the toothed discs can be easily exchanged in a few minutes.

NOTE: It is always necessary to change the toothed discs and springs at the same time!
To grease the toothed discs, the use of DT Swiss special grease is recommended.


Technical specifications:

Material: steel
compatible hubs: all DT Swiss hubs with ratchet system
Gearing: 54 teeth
Silver

Weight: 14g